General description
Paraformaldehyde (PFA) is the polymerization product of formaldehyde with a typical degree of polymerization of 8 to 100 units. Paraformaldehyde is not a fixative by itself; must depolymerize to formaldehyde in solution. In cell culture, the typical formaldehyde fixation procedure would involve the use of a 4% solution of formaldehyde in phosphate-buffered saline (PBS) on ice for 10 minutes. The fixation ensures that sample cell structures remain intact and antigens are immobilized, while ideally still allowing unrestricted access of antibodies to target antigens.
Our 4% paraformaldehyde is the most preferred binding agent as it creates covalent cross-links between molecules. This sticks them together, thus effectively preserving cells and tissue components. The use of this 4% paraformaldehyde can ensure the consistency of the physical and chemical properties of the cell, so there are no changes in the chemical and morphological characteristics of cells and tissues.
General description
Product name: 4% Paraformaldehyde (PFA) solution in PBS
SKU / Catalog Number: AR1068

Form: Liquid
Physical state: The solution should be clear, colorless, without precipitates.
Pack size: 500 ml
Storage: Store at -20˚C for one year.
Cite this product: 4% Paraformaldehyde (PFA) solution in PBS (Boster Biological Technology, Pleasanton CA, USA, Catalog # AR1068)
Equivalent: N / A
Properties
CAS number: 30525-89-4
MDL Number: MFCD00133991
Solubility: Soluble in water
pH: 7.0 – 7.6 at 25 ° C
Safety and handling
- Causes serious eye damage.
- Suspected of causing cancer.
- May produce an allergic reaction on the skin.
- Causes skin irritation.
- Avoid breathing dust / fume / gas / mist / vapors / aerosols.
- Wear protective gloves / protective clothing / eye protection / face protection.
- Store under lock and key.
- Dispose of contents / container in accordance with local / regional / national / international regulations.
General notes
- Adjust pH to 7.2-7.6 with NaH2PO4 if pH <7 after long storage.
- A deposition is normal for this product.
4% paraformaldehyde recipe
To prepare a 4% paraformaldehyde solution, you must use this protocol. The following ingredients are required:
- 1 M sodium hydroxide
- 10X phosphate-buffered saline (PBS)
- 1 M hydrochloric acid
Note: This should be done in a smoke chamber with gloves, safety glasses, and a mask.
- To prepare a 4% solution of paraformaldehyde (PFA) in PBS, add 4 grams of granular or granular paraformaldehyde to the water (H2O)
- Use a hot plate to heat the solution to 60 degrees centigrade. Add 1 ml of 1 M NaOH until the paraformaldehyde is completely dissolved.
- Add 10 ml of 10x Phosphate Buffered Saline (PBS) and allow the mixture to cool.
- Adjust the pH of the solution with 1 M HCl and then make the volume to 100 mL with H2O.
- Filter the solution to remove any deposits.
